It's time for a new standard in mercury emissions monitoring. Part of the Mercury Freedom System, the Model 83i is one of the four major components of this state-of-the-art system.
Product Detail
The Model 83i Mercury Probe is one of the four major components of the Mercury Freedom System.
The Model 83i consists of a dilution probe, inertial filter, and a proprietary dry converter/scrubber housed in an insulated NEMA 4X stainless steel enclosure. The probe has been specifically designed for monitoring mercury emissions from coal-fired power plants and waste incinerators. Artifacts due to interactions with the fly ash are minimized using a high-flow, sintered-metal inertial filter to provide a particle-free, vapor-phase sample for analysis. Automated blow-back helps to ensure trouble-free continuous operation, and all components exposed to sample gas are glass-coated to prevent reactions with mercury.
To prevent sample condensation, all key components (inertial filter, eductor, dilution module, and venturi) are further enclosed in a heated aluminum cabinet. The converter/scrubber converts oxidized forms of mercury to elemental mercury while removing interfering gases from the sample stream. Weighing only 92 pounds, the probe has been designed for easier maintenance and service. Latched panels are easily removed from three sides of the probe allowing quick access to the interior. Inside, the components are so easily accessed that they can be serviced or removed in a matter of minutes.
Designed to meet the provisions of 40CFR Parts 60 and 75, the Mercury Freedom System provides a complete mercury monitoring solution that measures elemental, ionic, and total mercury in exhaust stacks from both coal-fired boilers and waste incinerators.
Key Features
Dilution system for wet basis measurement
High flow inertial filter to reduce particulate matter contamination
Glass coated components to prevent reactions with mercury
Conversion at the stack to prevent loss of elemental mercury
Proprietary dry converter/scrubber requires no wet chemistry or water supply
Main enclosure: 304 stainless steel; Glass coated inertial filter: 316L stainless steel; Dilution sampler: 316L stainless steel, glass coated; All wetted parts are made of 316L stainless steel.
Installation :
The probe mounts via a 2" ANSI flange to the mantle assembly which has a 4" ANSI flange. This 4" flange is then mounted to the sample port. The sample inlet is a 1/2" tube and sample outlet is a 3/4" tube.
Power Requirements :
All power supplied by the Model 82i Mercury Probe Controller
1 Artículos Total 7,000.00 USD 
